EMS (Enhanced Geothermal Systems) is a new method for the 21st century to solve the global demand for clean energy. The original concept has been proposed in the 1970s but has not been taken seriously because the geothermal distribution area is extremely Restricted, it was suggested that deep drilling technology could be used to drill anywhere near 300 degrees of lava near the underground lava. At least 2 wells were injected into the well to recover geothermal steam to generate electricity. If the cost allows more recovery wells to be drilled It can reduce the loss of steam; increase the power generation efficiency.
Although the principle is simple, but because the required depth of the well is as deep as 5 km or more, and through many hard granite crusts, the traditional drilling method needs to wear hundreds of high-priced drill bits, which is too costly, and the ground conditions are difficult to grasp, and it is possible that the water vapor cannot be circulated. The waste wells, coupled with geothermal heat in the mass media, are not as high as solar energy and wind power, and many factors make people reluctant to invest and stop at the experimental stage.
However, the concepts of emerging technologies such as hydrothermal rigs and plasma rigs have been proposed, and drilling costs are expected to drop sharply. At that time, geothermal energy can provide 24-hour stable base-load capacity without location and climate impact. Construction time, cost and public concerns are far away. Below nuclear energy; it is expected to be the most competitive green energy and global warming solution.
Flexible Rubber magnets are compound materials made by mixing Ferrite Magnet powder and rubber. Pressing or rolling makes the finished flexible Rubber Magnet. Because the material has good plasticity, the finished flexible rubber magnets or semi-manufactured flexible rubber magnets can incise, stiletto, slit or back up other materials randomly, have good antisepsis and difficult demagnetization. The raw materials are plentiful, so the price is lower. Flexible Rubber magnets are natural Flexible Rubber magnets or isomer Flexible Rubber magnets. Natural rubber magnets have weak magnetism, are used on iceboxes, presswork and marketing and promotion premiums. Isomer rubber magnets have strong magnetism, and are used in such applications as micro-motors and magnet toys.
Rubber magnet by the magnetic (SrO6Fe2O3), polyethylene (CPE) and other additives (EBSO, DOP) etc., by extrusion, calendering made of.Rubber Magnets areas of application: refrigerator, notices the message frame, the object fixed on the metal body of the fasteners to be used as advertisements for toys, educational equipment, switches and sensors disk.Mainly used in motor, refrigerator, disinfection cabinet, kitchen cabinets, toys, stationery, advertising and other industries.
Rubber Magnet
Rubber Magnet,Permanent Rubber Magnet,PVC Covered Rubber Magnet,Strong Strength Rubber Magnet
Jinyu Magnet (Ningbo) Co., Ltd. , http://www.magnetbonwin.com