Toilet ware is one of the most frequently used household products in our daily use. Only good quality + good installation can reflect good value. After purchasing a satisfactory sanitary ware, how to install the high quality requires the owner to spend some time.
The construction of the installation is still mainly done by the workers. The main thing I mentioned here is how the workers operate the specifications and how to accept them.
Operating specification
First, the toilet
1. With a water tank and a one-piece toilet, the back of the tank should be no more than 20mm from the wall;
2. The height of the overflow pipe in the flushing tank should be 30~40mm below the wrench hole to prevent the water from overflowing from the wrench hole when the inlet valve is damaged.
Second, the washbasin
1. The upper surface of the bathtub installation must be leveled with a horizontal ruler.
2. After the washing basin is connected with the drain pipe, it should be firm and compact, and easy to disassemble. The joint should not be open. Silicone paste caulking is applied to the wash basin and wall contact.
Third, the shower
1. Generally speaking, the shower head and faucet of the shower are all installed and used. The faucet is 70-80 cm from the ground, the shower column height is 1.1 m, the length of the faucet and shower column joint is 10-20 cm, and the shower is from the ground. The height is between 2.1 and 2.2 meters, and consumers should fully consider the size of the bathroom space when purchasing.
2. The cold and hot water supply pipes must not be reversed. Under normal circumstances, the left side of the faucet is a hot water supply pipe, and the right side is a cold water supply pipe. Except for special signs. After the installation is completed, remove the blisters, showers, etc., which are easy to block the fittings, let the water flow out, completely remove the impurities, and then put them back.
Acceptance considerations
1, the toilet is too close to the glass door
Because there are too many sanitary wares to be placed, the distance between the toilet and the glass partition door is too narrow.
Only one foot can be lowered, which may affect the comfort of the toilet.
2, the measurement is not allowed to the goods is not on the board
The diameter of the water pipe under the toilet is 11 cm, 33 cm from the wall. Since the floor tiles have not been attached during the rough test, the results are inconsistent with the post-laying, resulting in a mismatch between delivery and actual delivery.
3, the hot and cold water port installation is not in place
The hot and cold water outlet of the shower faucet was not installed during the hydropower transformation. As a result, when the S tube was installed, the screw and the faucet could not be completely fitted, and some of the tube rings were exposed, which was not beautiful enough, but did not affect the use.
321 Pipe,Tp321 Pipe,Tp321 Austenitic Tube,Stainless Steel Seamless Pipe
Zhejiang Ruimai Stainless steel Tube Co.,Ltd. , https://www.ruimaitube.com