Many owners complain that the color of the paint on their walls is not uniform, uneven or there are traces of touch up paint. This is probably due to the carelessness of the master decorator in the painting process on the wall. It is best for owners to first understand what steps are needed for the entire painting process. What do you need to pay attention to? If you know what to do, you can prevent it as soon as possible.
Steps and details can not be ignored
Paint can be divided into 6 steps. The first is preparation. The door, window frame, furniture and paint connection, paste color paper protection. Well-made wooden cabinets, partitions and other furniture should be sealed with newspapers so as not to be soiled by paint.
The second is color adjustment. For walls that require color, the area should be accurately calculated in advance and the materials used should be evenly distributed. Then the primer is applied to prevent the wall surface from being wet and the color of the top coat is uniform. This prevents the appearance of water stains on the boards.
The third is roller coating construction. The order of topcoat construction: ceiling, lines, and back wall. Paint on the wall at least two times, the first time the paint can be added 5% to 10% of the water, to facilitate the absorption of the wall, the second time the paint can not add water, with the first pass of the coating there is a certain interval. Roller coating requires the use of two roller brushes at the same time. The coarse roller brush is followed by the roller brush. Use a thick roller to evenly paint the paint on the wall. Use a fine roller to brush over the rough roller. Brush it again to make the wall paint delicate and brush out the desired pattern.
The fourth is brush construction. Use a brush to make up the paint on the edges of the wall and corner of the brush.
The fifth is polishing the wall. When the paint on the wall is dry, sand the wall with sandpaper to reduce the brush marks on the wall and make the wall more smooth. When polishing, be careful to feel the smoothness of the wall from time to time in order to judge where to polish. It should be noted that when sanding, try to use finer sandpaper. Generally, the softer putty is used with No. 400~500 sandpaper, and the harder texture is No. 360~400. After thoroughly polishing, thoroughly clean the wall.
Sixth, cleaning and inspection. Clean the paint marks on the foot line and other places, check whether the color of the wall meets the design requirements, and whether the color of the brushing surface is the same, so as to prevent the bottom, the brush, the powder, the bubbling, the bite color and the flow drop. And other quality defects.
Wall construction experience on three trees lacquer furniture coating decoration design window
Neodymium Magnet,NdFeB Magnet,Ferrite Magnet
Sunxal Magnetics Co., Ltd. , http://www.hlmagnets.com