We all know that there are many different types of hot water pipe pump models, each of the different models of their working conditions, structure, performance parameters may be different, the following brief introduction to the next IRG Hot water pipe working conditions, structure and performance parameters. Working conditions: 1. Inhalation pressure ≤1.0MPa, or the maximum working pressure of the pump system ≤1.6MPa, that is suction inlet pressure + pump head ≤1.6MPa, pump static pressure test pressure ≤2.5MPa, please indicate the system working pressure when ordering . Pump system operating pressure greater than 1.6MPa should be separately ordered when ordering, in order to manufacture pump overcurrent part and the coupling part of the cast steel material. 2. Ambient temperature <40 ℃, relative humidity <40%. 4. The conveying medium solid particles volume content does not exceed 0.1 per unit volume, particle size <0.2mm. Note: If the medium with small particles, please specify when ordering, so that the factory wear-resistant mechanical seal. IRG type hot water pipeline pump structure is as follows: 1. Impeller; 2. Pump body; 3. Mechanical seal; 4. Retaining ring; 5. End cap; 6. Impeller nut; 7. Pump shaft; 8. Motor type IRG Hot water pipeline pump performance parameters are as follows: IRG hot water pipeline pump structure and performance parameters Xiaobian has been used in the most simple, the most easy to understand chart out, I believe you IRG-type hot-water pipeline pump structure and Performance parameters have been further understanding and understanding, I hope this concise expression can really help you. Further reading: Canton IFAT China Water Show article belongs to the construction industry interconnect (Xiamen) Co., Ltd. All are welcome to reprint, please indicate the source and author of: Asian pumps Network Editor: lindj (QQ / micro-channel: 181 817 456) Starting: http://beng.liuti.cn/ (Service Hotline: 400-6030-811)