YCB 25 / 0.6 arc gear pump adopts internationally the most advanced pump that continuous contact with a little gear, that is, double arc plus sinusoidal compound into tooth shape, can be completely eliminated involute gear pump. Won the national major scientific and technological achievements project, and won the third prize of progress of science and technology by the State Education Commission. Circular arc gear in a continuous contact between the two meshing tooth profile, will not produce trapped oil phenomenon, completely solve the involute gear pump due to oil pump vibration, noise, bearing load increases and so on. Therefore, YCB 25 / 0.6 arc gear pump with efficiency, low noise, and has a good energy saving effect. YCB 25 / 0.6 arc gear pump surface sticky coating principle and characteristics: In recent years YCB 25 / 0.6 arc gear pump surface sticky coating technology in China has been widely used in equipment maintenance, suitable for a variety of materials, parts and equipment The repair. Its working principle is to add molybdenum disulfide, metal powder, ceramic powder and fiber and other special filler adhesive, directly applied to the surface of materials or parts, so that it has a wear-resistant, corrosion and other functions, mainly for surface strengthening and repair . Its process is simple, convenient and flexible, safe and reliable, does not require specialized equipment, just a good glue coated on the surface of the cleaned parts to be cured after curing can often operate at room temperature, will not make the parts Produce thermal equivalent effect and deformation. Arc pump mold temperature machine introduction The best YCB 25 / 0.6 arc gear pump heating method should be hot oil heating. Continuous hot oil through the mold within the pipeline, from the internal mold heating, the mold to achieve the status suitable for production. Because HTF can not only heat, but also water-like cooling, the function like a heat exchanger, can maintain the mold temperature within a certain range, even if the production interruption can also be properly maintained mold temperature. Circular arc pump mold temperature machine using high thermal conductivity of the thermal media, so that in a very short period of time will die away from the excess heat. After setting the thermal equilibrium temperature, the mold temperature controller can automatically control its temperature within the minimum error and maintain the constant value.
Iron Wire Co., Ltd. , http://www.farm-fences.com